Mircom FA-300 Series Manuel d'installation télécharger pdf (Page 54)

Configuration

2. Config Info (Command-Menu)

Note: Refer to How to Use the Keypad to Program the FA-300 on page 39 for detailed instructions on

making menu selections.

Press down arrow key to see more

information.

Configuration type will show how the panel was configured.

“Factory default” means the panel has not been configured,

it is as it came from the factory. “Front Panel” means it was

configured at the panel. “Serial Port” means the

configuration was done from a computer through the serial

port. “Modem” means the configuration was completed

remotely through a modem.

If you upload a job configuration to the panel using the PC

configuration utility, the job name will appear on this

screen. The job name can be up to a maximum of 20

characters.

Press down arrow key for further

info

If you upload a job configuration to the panel using the PC

configuration utility, the technician’s name (ID) will appear

on this screen. The technician ID can be up to a maximum

of 10 characters.

Press down arrow key for further

info

Configuration date and time will appear for all means of

configuration, thus revealing date and time configuration

was last changed.

This specifies the configuration tool version. It will display

0.0.0.0 if no PC configurator has been used.

Configuration type:

Factory default

Job Name:

No job loaded

Technician ID:

Unknown

Cfg. Date and Time:

hh:mm day year:mm:dd

Cfg. Tool S/W Vers.:

Version:x.x.x.x

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 83 84

Pas de commentaire

Mircom FA-300 Series Manuel d'installation Page 54