Mircom FA-300 Series Manuel d'installation télécharger pdf (Page 3)

Cautions and Warnings

READ AND SAVE THESE INSTRUCTIONS. Follow the instructions in this

installation manual. These instructions must be followed to avoid damage to this

product and associated equipment. Product operation and reliability depends upon

proper installation.

DO NOT INSTALL ANY PRODUCT THAT APPEARS DAMAGED. Upon unpacking

your equipment, inspect the contents of the carton for shipping damage. If damage

is apparent, immediately file a claim with the carrier.

ELECTRICAL HAZARD - Disconnect electrical field power when making any

internal adjustments or repairs. Servicing should be performed by qualified

personnel.

STATIC HAZARD - Static electricity can damage components. Therefore, handle as

follows:

• Ground yourself before opening or installing components

• Prior to installation, keep components wrapped in anti-static material at all

times.

RADIO FREQUENCY ENERGY - This equipment generates, uses, and can radiate

radio frequency energy and if not installed and used in accordance with the

instruction manual, may cause interference to radio communications. It has been

tested and found to comply with the limits for a Class A computing device pursuant

to Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable

protection against such interference when operated in a commercial environment.

Operation of this equipment in a residential area may cause interference in which

case the user at his own expense will be required to take whatever measures may

be required to correct the interference.

SYSTEM REACCEPTANCE TEST AFTER SOFTWARE CHANGES - To ensure

proper system operation, this product must be tested in accordance with NFPA72-

1996, Chapter 7 after any programming operation or change in site-specific

software. Reacceptance testing is required after any change, addition or deletion of

system components, or after any modification, repair or adjustment to system

hardware or wiring.

All components, circuits, system operations, or software functions known to be

affected by a change must be 100% tested. In addition, to ensure that other

operations are not inadvertently affected, at least 10% of initiating devices that are

not directly affected by the change, up to a maximum of 50 devices, must also be

tested and proper system operation verified.

1 2 3 4 5 6 7 8 ... 83 84

Pas de commentaire

Mircom FA-300 Series Manuel d'installation Page 3