Mircom FA-300 Series Manuel d'installation télécharger pdf (Page 42)

Supported Protocols/Devices

Synchronous Strobes

The synchronous strobe models that are supported by the FA-300 panel include Mircom models FHS-240 and

FS-240. A separate compatibility list is available for different supported models.

Strobes can be configures as normal (e.g. not synchronized or any of the above; see configuration section). Any

selection made is system-wide (e.g. whatever is selected applies to all the circuits in the system, configured as

strobes).

“Signal silence” action on strobes

The “signal silence” action on strobes depends upon the configuration. The following describes the signal silence

action on non-silenceable and silenceable strobes.

Non Silenceable strobe

If the output zone is configured as Non-Silenceable Strobe and if the “signal silence” is active on the panel while the

strobes are active, the horn should be silenced. If the signal is active again the panel will activate the horn again.

Silenceable strobe

If the output circuit is configured as Silenceable Strobe, and if the “signal silence” is active on the panel, both the

horn and strobe are completely turned off by turning off the output circuit. Re-activating the “signal silence” will turn

them on again.

System Sensor’s i

Devices

The FA-300 fire control panel supports System Sensor’s i

devices. Only the two wire smoke detectors are

supported on the i

zone, which are 2W-B and 2WT-B. Model 2WT-B features a build in fixed temperature (135F /

57.2C) thermal detector and is capable of sensing a freeze condition i.e. if the temperature is below 41F / 5 C.

The zones should be programmed to i

devices to be considered as i

zone (see configuration section). If the zone

is not programmed as i

zone and i

devices are connected to the zone, it is simply treated as a regular zone. The

panel is capable of detecting multiple troubles; if different devices have different troubles on the same zone, all

troubles will be reported. The following troubles are reported for the i

devices.

zone Troubles

The following troubles can be reported for a zone configured as i

zone:

• Open circuit trouble

• Communication trouble

• Out of sensitivity: defective or dirty device

• Freeze trouble

Note: Please see the strobes manufacturer’s data for details.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 83 84

Pas de commentaire

Mircom FA-300 Series Manuel d'installation Page 42