Mircom TX3 Series Manuel de démarrage rapide télécharger pdf (Page 137)

Configuring a Card Access System Panel

Version 2.4 TX3 Configuration and Administrator Manual 137 (165)

High security is off. When disabled all access cards are able to open

the door.

At access point/Input label. This parameter defines the access point or

input.

Action. Action specifies the type of action to occur for a specific input.

Select one of the following:

Turn ON general output. When enabled the output assigned a

specific function performs the required action.

Turn OFF general output. When disabled the output assigned this

specific function does not perform the designated action.

Turn ON high security. When enabled only access cards with this

privilege are able to open the door.

Turn OFF high security. When disabled all access cards are able to

open the door.

On panel. On panel applies the action to the selected panel. All

networked panels appear, in this example panel 1 and panel 2 are listed.

Select one of the following:

Panel1 (card)

Panel2 (card)

All

Note: All also applies to any Telephone Access Panels on the network.

Output. This parameter applies the action to a specific output or access

point on the panel. For an output to appear on this list it must be designated

as a general purpose output. For a reader to appear on this list the output

must be assigned to a reader. For a Job that uses two outputs and two

readers, select one of the following:

Output 3

Output 4

Reader A

Reader B

For. For represents the duration of the action in minutes and seconds up

to a maximum of 600 minutes. Uncheck the box if you want the action to

continue indefinitely.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 164 165

Pas de commentaire

Mircom TX3 Series Manuel de démarrage rapide Page 137