126 (165) TX3 Configuration and Administrator Manual Version 2.4
Copyright 2012 LT-995
Configuring a Card Access System Panel
To set the card access panel
1. Click Panel. The Panel Configuration window appears:
Figure 90. Panel Configuration - Card Reader
2. Provide information for each the following:
Select card format to support. Select the card reader format for each
access point, 26-bit Wiegand or 37-bit Mircom. When both formats are
used by the same controller, select both.
Report real time events to PC. Enable or disable real time event sending
to the PC. If enabled, only the real time logs are sent to the PC.
Facility code. Enter the building’s facility code with a value from 0 to
4294967294. Enabling the facility code mode lets you grant access to
cards based on facility code.
Interlock. If enabled door B cannot be unlocked until door A is locked
and closed. Door A cannot be unlocked until door B is locked and closed.
Date and Time button. Select this option to set the daylight savings time.
3. Proceed with another configuration or click Send and Exit from the
Tool Bar to apply the settings and exit the session.
Commentaires sur ces manuels